3618 User Guide: Difference between revisions

From Phidgets Support
No edit summary
No edit summary
 
(One intermediate revision by the same user not shown)
Line 1: Line 1:
__NOINDEX__
<metadesc>This LED module is RGB and adhesive-backed, useful for halo lighting and sign lighting and can be cut anywhere on the wires between each module.</metadesc>
[[Category:UserGuide]]
[[Category:UserGuide]]
{{UserguideTOC|3618.jpg|3618}}
{{UserguideTOC|3618.jpg|3618}}

Latest revision as of 20:58, 8 May 2018


3618.jpg
Go to this device's product page


Introduction

This manual describes how to connect and control the 3618 LED module using Phidgets I/O boards and relays.

I/O Boards:

Relays:

Connecting the LED Module

Connecting to the REL1100 or REL1101

3618 0 Connecting VINT.jpg

  1. Connect the ground (-) wire from your power supply to one of the ground terminals on the Phidget.
  2. Connect the black anode wire from the LED module to the power supply live wire (+).
  3. Connect the red, blue, and green cathode wires from the RGB module to the numbered terminals on the Phidget.

Connecting to the 1012 - PhidgetInterfaceKit 0/16/16

3618 0 Connecting 1012.jpg

  1. Connect the ground (-) wire from your power supply to the ground terminal (G) on the 1012.
  2. Connect the black anode wire from the LED module to the power supply live wire (+).
  3. Connect the red, blue, and green cathode wires from the RGB module to digital output terminals.

Note: Be aware that the LEDs can get damaged if the proper polarity is not respected: Anode (+), Cathode (-).

3618 0 Functional 1012.jpg

Connecting to the 1014 - PhidgetInterfaceKit 0/0/4

3618 0 Connecting 1014.jpg

  1. Connect the black anode wire from the LED module to the power supply live wire (+).
  2. Connect the ground (-) wire from your power supply to a Common terminal on the 1014.
  3. Connect the Red, Green and Blue cathode wires from the LED module to the NO (Normally Open) terminals on the 1014.
  4. Insert jumpers between the common terminals.

If you connect the power supply live wire to the NC (Normally Closed) terminal, the LED strip will be ON when the switch is off.

Note: Be aware that the LEDs can get damaged if the proper polarity is not respected: Anode (+), Cathode (-).

3618 0 Functional 1014.jpg

Connecting to the 1017 - PhidgetInterfaceKit 0/0/8

3618 0 Connecting 1017.jpg

  1. Connect the black anode wire from the LED module to the power supply live wire (+).
  2. Connect the ground (-) wire from your power supply to a Common terminal on the 1017.
  3. Connect the Red, Green and Blue cathode wires from the LED module to the NO (Normally Open) terminals on the 1017.
  4. Insert jumpers between the common terminals.If you connect the power supply live wire to the NC (Normally Closed) terminal, the LED strip will be ON when the switch is off.

Note: Be aware that the LEDs can get damaged if the proper polarity is not respected: Anode (+), Cathode (-).

3618 0 Functional 1017.jpg
Retrieved from "https://www.phidgets.com/docs/index.php?title=3618_User_Guide&oldid=29304"