Template:DCBLDCMotor DriveMode: Difference between revisions
| Line 36: | Line 36: | ||
}} | }} | ||
The graph below shows reiterates the information from the table. | |||
[[Image:Coast_mode_current_scaling_graph.png|center|500px|link=https://cdn.phidgets.com/docs/images/8/8e/Coast_mode_current_scaling_graph.png]] | |||
====Forced Mode==== | ====Forced Mode==== | ||
Revision as of 21:11, 14 January 2025
The Drive Mode allows you to configure the deceleration of your motor and the amount of current that is available to your motor at any given moment. There are two modes to choose from:
- Coast Mode (default behavior)
- Forced Mode
Coast Mode
Coast Mode is the default behavior. In this mode, your motor will coast (freewheel) while decelerating. This is similar to the deceleration experienced when releasing the gas pedal in a car.
Other Considerations
When using Coast Mode your Current Limit will scale based on your motor's Velocity.
The table below shows the impact of different Velocity values on the Current Limit for a controller with a minimum Current Limit of 5A.
| Drive Mode | Velocity (duty cycle) | Current Limit (A) | Active Current Limit (A) |
|---|---|---|---|
| COAST | 1.0 | 20 | 20 |
| COAST | 0.5 | 20 | 10 |
| COAST | 0.1 | 20 | 5* |
| COAST | -0.5 | 20 | 10 |
*The minimum Current Limit is 5A.
The graph below shows reiterates the information from the table.
Forced Mode
In Forced Mode your motor will aggressively slow down, often regenerating power in the process.
Other Considerations
When using your Phidget in this mode, you will have full access to your Current Limit.
The table below shows the impact of different Velocity values on the Current Limit for a controller with a minimum Current Limit of 5A.
| Drive Mode | Velocity (duty cycle) | Current Limit (A) | Active Current Limit (A) |
|---|---|---|---|
| FORCED | 1.0 | 20 | 20 |
| FORCED | 0.5 | 20 | 20 |
| FORCED | 0.1 | 20 | 20 |
| FORCED | -0.5 | 20 | 20 |
