After a few hours of operation, all of the modules on my VINT HUB detach and the HUB no longer shows up on the Phidget Control Panel. The only way I can recover is to disconnect and re-connect the USB cable. I tried 4 different computers: some can run for days before a fault. It appears to be caused by a USB communication error.
Is there a software method to reset the HUB?
I started Phidget Control Panel and tested the LCD module. Worked fine. Then started the stepper. Shortly after that the LCD module (located on it's own HUB) failed. In about 1 minute, the stepper failed and all the phidget modules disappeared from the Phidget Control Panel.
Once again: This looks more like a USB problem than a issue with the Phidget modules. I would like to be able to recover from the fault without having to unplug the USB cables.
Attached is the LOG.
Patrick,
I checked the cables and power supplies. They look good. I downloaded the latest Phidget Control Panel and updated the firmware on all of the modules.
I now get a slightly different response. Soon after I start the stepper (continuous mode) I get a "Timeout Error". The stepper continues to move and can not be stopped. (more timeout errors). The other modules (relay, encoder, temp sensor, LCD and 2 hubs) do not appear to be affected and continue working. Unplugging the communication cable from the stepper has no effect. Unplugging the USB cable has no effect. The only way to stop the stepper is to remove the power. Any ideas?
Solved!
During the test, I was using a SIIG USB Extenter. Everything worked except the VINT Stepper. When I tested the 1067 stepper, it was connected without the Extender. I swapped the SIIG Extender with a IOGEAR Extender and the problem went away. I know: I should have removed the Extender in the first place, but the Phidget modules are about 100 feet from the computer.
