Phidgets Forums

You can recover the firmware on the SBC itself using the phidget22admin command line tool. You'll need to SSH into the SBC and run:

phidget22admin -M 592703/0 -U

If it fails, remove power and the vint cable from your vint device, then plug it back in and try again.

-Patrick

Now THAT is the kind of answer I was expecting. Thanks very much!

Patrick wrote:You can recover the firmware on the SBC itself using the phidget22admin command line tool. You'll need to SSH into the SBC and run:

phidget22admin -M 592703/0 -U

If it fails, remove power and the vint cable from your vint device, then plug it back in and try again.

-Patrick

Thanks once again Patrick. That solved the issue.


Wouter