Changing Reference Output voltage on 8/8/8 from 5V to 3.3V

[vreinha]

Hi,
I think I know the answer already but I will ask. I looked through the forums but didn't see an answer for this one. On the 8/8/8 Digital Outputs, is it possible to change the reference ouput voltage. That is make the output 3.3V instead of 5V. I think I might have order the wrong hardware.

Would a voltage divider on every pin work as well as long as the current is low?

Regards,
V

[vreinha]

I think I had the wrong circuit. I will try the following to get 2.5V output.
-V