Page 1 of 1
Phidget SBC4 VINT Por Issue
Posted: Fri Dec 03, 2021 1:35 pm
by AngelBorjas
Hello,
I have an issue with the Phidget SBC4 SBC3003_0
Today I receive a firmware update request. Before update, the versions are: Firmware 2.0.0 - Version 400 and now the Phidget software don't show any VINT ports on the control panel. I installed the latest version of Phidget control panel software and the issue persists.
Any suggestions?
Re: Phidget SBC4 VINT Por Issue
Posted: Fri Dec 03, 2021 3:57 pm
by Patrick
Hi,
Refresh and upgrade packages in the SBC web interface to ensure you are running the latest libraries on the SBC, then do a reboot of the SBC.
Where did you perform the firmware upgrade? In the SBC web interface, or in a Control panel on Windows/macOS?
-Patrick
Re: Phidget SBC4 VINT Por Issue
Posted: Thu Dec 09, 2021 7:43 am
by AngelBorjas
Patrick wrote:Hi,
Refresh and upgrade packages in the SBC web interface to ensure you are running the latest libraries on the SBC, then do a reboot of the SBC.
Where did you perform the firmware upgrade? In the SBC web interface, or in a Control panel on Windows/macOS?
-Patrick
Hi Patrick.
I perform the firmware upgrade from the Control Panel, version 1.8.20211202.
The Phidget worked perfectly after performing the steps you mention. And now recognizes the VINT ports. Thank you.
I have a question, every time the SD is flashed with the Debian OS, will it be necessary to do these steps?
Re: Phidget SBC4 VINT Por Issue
Posted: Mon Dec 13, 2021 5:22 pm
by Patrick
Hi,
Yes, if you re-flash the SD card, you would need to upgrade the packages again.
If this is an issue, you could create your own SD image for flashing from your SD card after upgrading packages.
Also, Phidgets does update the image from time to time.
-Patrick