Phidgets Forums

I have a very old textlcd board with a 4 pin connector in place of the current usb connector. Naturally I have lost the special cable and need a replacement, any ideas what I should be asking for?

thanks

You need a 3016_0 https://www.phidgets.com/?tier=3&prodid=165

Unfortunately we don't sell them anymore. I'm not sure if you'll be able to source one.

-Patrick

it doesn't look that complicated, maybe I should just make one. Can you tell me the connector type and pin out?

thanks

The connector is the Molex 0050579404, and you'll need the associated crimp pins (
0016020102)

The pinout is as follows:
Red - USB 5V
White - USB Data-
Green - USB Data+
Black- USB Ground

thanks!

You could buy one of the LED64 cables (same connector), a USB cable, cut them up, and solder them together.

https://www.phidgets.com/?prodid=590

-Patrick