Circular Touch hole drilling

[Lincon]

Hello everyone,,,
I have a question regarding the Phidget Circular touch, I know from the looks of the product that you could completely remove the very center of it where there are no components, but there where the 8 areas are for touching, could you drill a small hole in the center of it without destroying it? (1-5mm diameter)

Lincon.

[mparadis]

It should be fine to drill a small hole in the middle of the board where there are no components or touch regions.

(Note: we do not recommend this for higher powered Phidgets e.g. motor controllers)