Phidgets Forums

Hi,

I have a project with 5 VINT wireless hubs connected via ethernet with a ton of assorted Phidgets connected. Any suggestions on how I can have the program pause (I'll put a progress bar or something up) until everything is attached before continuing?
This is only an issue when I am trying to 'home' a stepper motor and the 16x Digital Input that reads it's limit switch doesn't attach in time to do it's job.
I want to make sure everything is attached because there is a lot of components that depend on each others conditions to work properly and I am stumped on how to do it.
Thanks,
Dan

You can use the Attached property of your Phidgets to determine whether they are attached.
From there, you can write a loop that holds your program until all channels are attached.