Worm Gearboxes

This shaft is designed to fit into a worm gearbox and act as an output shaft. You can install it by following these steps:

• Put the keys into the keyways on the shaft.
• Slide the shaft through the gearbox until it's centered inside.
• Slide washers onto both ends of the shaft.
• Put snap rings onto both ends of the shaft so that the washer is between the snap ring and the gearbox (There is a groove at the end of the shaft for the ring to rest inside).

Product		Gearbox Properties
Part Number	Price	Gearbox Series	Gear Ratio	Maximum Strength of Gears	Input Shaft Diameter
TRM4404_0 234Nm 75 Series Worm Gearbox 30:1	$155.40	75	30 : 1	234 N·m	24 mm

Shaft Couplers

If you need to connect this shaft to a motor or another device with a shaft, you can use a shaft coupler:

Product		Physical Properties
Part Number	Price	Inner Diameter	Coupling Rated Torque	Coupling Rated Speed
TRM4331_0 Jaw Coupling Half 35mm Series 38	$7.40	35 mm	3.3 Mg·cm	4000 RPM

Product Specifications

Documents

• Mechanical Drawings
• Rotary motion Guide