Changing Reference Output voltage on 8/8/8 from 5V to 3.3V
Posted: Fri Aug 28, 2020 12:00 pm
Hi,
I think I know the answer already but I will ask. I looked through the forums but didn't see an answer for this one. On the 8/8/8 Digital Outputs, is it possible to change the reference ouput voltage. That is make the output 3.3V instead of 5V. I think I might have order the wrong hardware.
Would a voltage divider on every pin work as well as long as the current is low?
Regards,
V
I think I know the answer already but I will ask. I looked through the forums but didn't see an answer for this one. On the 8/8/8 Digital Outputs, is it possible to change the reference ouput voltage. That is make the output 3.3V instead of 5V. I think I might have order the wrong hardware.
Would a voltage divider on every pin work as well as long as the current is low?
Regards,
V